Mechanical & Engine Failure · NTSB CEN17FA207

VARGA AIRCRAFT CORP. 2150A — Bowling Green, OH

1 fatal
DateJune 1, 2017
LocationBowling Green, OH
AircraftVARGA AIRCRAFT CORP. 2150A
Purpose of flightPersonal
ConditionsDay · Visual Meteorological Cond
Phase / occurrencePrior to flight Aircraft maintenance event
Pilot age70
Pilot total time793 hrs · Building experience
Time in typeUnknown
Fatalities1

Probable cause

The pilot's loss of control due to impairment from carbon monoxide poisoning. Contributing to the accident was the corrosion of the heat exchanger and the failure of maintenance personnel to adequately inspect and repair or replace the exchanger during the most recent annual inspection.

NTSB findings

  • Personnel issues-Task performance-Use of equip/info-Aircraft control-Pilot
  • Personnel issues-Physical-Impairment/incapacitation-Carbon monoxide-Pilot
  • Aircraft-Aircraft power plant-Engine exhaust-(general)-Fatigue/wear/corrosion
  • Personnel issues-Task performance-Maintenance-Scheduled/routine maintenance-Maintenance personnel

What happened

The private pilot was performing a visual flight rules cross-country flight after purchasing the airplane. After flying for about 1 hr 20 minutes, the airplane suddenly entered a spiraling descent from cruise flight. Witnesses observed the airplane flying erratically at low altitude before it impacted an open field; they stated that the engine was running until impact.

Toxicological testing of specimens taken from the pilot found 55% carbon monoxide saturation of blood. At carbon monoxide levels above 40%, people typically experience incapacitating symptoms such as severe confusion, agitation, seizures, loss of consciousness, and death.

Examination of the airplane's heat exchanger showed that the outside casing had either previously been repaired or had been originally constructed of metals with different properties. About one-half of the casing was discolored and exhibited varying signs of corrosion (the other half did not). Small holes were found where corrosion had occurred in the casing material. The holes from the corrosion provided a means for carbon monoxide to enter the cockpit from the exhaust system.

Federal guidelines for annual aircraft inspections require an inspection of the exhaust systems for cracks, defects, and improper attachment during each 100-hour or annual aircraft inspection. Maintenance logbooks indicated that the airplane's most recent annual inspection was completed less than 1 month before the accident. The available maintenance logbooks did not contain any record of repairs or replacement of the heat exchanger. However, the condition of the heat exchanger is indicative of an insufficient annual inspection that did not detect and correct the corroded heat exchanger.

It is likely that impairment caused by acute carbon monoxide poisoning led to the pilot's loss of airplane control. The corrosion in the heat exchanger allowed carbon monoxide to enter the cabin.

An editorial "what led to it / how to avoid it" analysis for this accident is generated separately and will appear here.

View the official NTSB docket →